- Last edited 119 days ago
Unpack the STM32MP157x-EV1 board
This first stage explains the way to unpack the STM32MP157x-EV1 Evaluation board and the additional equipment you need.
The following block diagram provides you high level information about how to connect them together.
2 Out of the box
The following table lists the required equipment to start playing with your STM32MP157x-EV1 board.
Some of them are delivered with the STM32MP157x-EV1 Evaluation board. The others need to be purchased separately.
|STM32MP157x-EV1 Evaluation board||Full feature board for the STM32MP15 microprocessor device||Delivered|
|MicroSD card||To be populated with the OpenSTLinux Distribution (Linux software)
and providing extra storage capacity.
A 2-Gbyte minimum microSD card is needed
|Power Supply 5V/3A||The power supply should be able to output 5V / 3A (15W)||Delivered|
|Micro USB Type-B to USB Type-A cable||Used to connect the STM32MP157x-EV1 Evaluation board to the PC
through the USB micro-B (ST-LINK/V2-1)
|Micro USB Type-B to USB Type-A cable||Used to connect the STM32MP157x-EV1 Evalutation board to an USB OTG device.||Not delivered|
|Laptop||Assumed a Linux PC running Ubuntu 16.04||Not delivered|
|Ethernet cable (optional)||Used to connect the STM32MP157x-EV1 Evaluation board through ssh||Not delivered|
- Connect the micro USB Type-B to USB Type-A cable between your laptop and the ST-LINK/V2-1 port of the board
- Connect the power supply
- Connect the micro USB Type-B to USB Type-A between your laptop and the USB Type-C™ OTG port of the board
- Optionally connect the Ethernet cable between your Ethernet network and the Ethernet port of the board
- Remove jumper JP1 and place jumpers JP4 and JP5 as shown below to allow debug through ST-LINK/V2-1
|Press with your fingers on the display to be sure it is well connected and screw the screws. The 3 LEDs at the right of the display should be green when the board is powered up.|