This message will disappear after all relevant tasks have been resolved.
Semantic MediaWiki
There are 1 incomplete or pending task to finish installation of Semantic MediaWiki. An administrator or user with sufficient rights can complete it. This should be done before adding new data to avoid inconsistencies.Track the most recent changes to the wiki on this page.
List of abbreviations:
- N
- This edit created a new page (also see list of new pages)
- m
- This is a minor edit
- b
- This edit was performed by a bot
- (±123)
- The page size changed by this number of bytes
22 November 2024
| N 16:38 | Connectivity:Bluetooth qualification workspace example with STM32WBA55CG diffhist +6,475 Registered User (page creation) | ||||
| N 15:26 | Connectivity:Bluetooth qualification workspace example with STM32WB5M module diffhist +6,411 Registered User (page creation) | ||||
| N 09:47 | File:signingTool.png diffhist +30 Registered User (Created page with "Category:STM32 SigningTool") | ||||
21 November 2024
| N 18:18 | Connectivity:Bluetooth qualification workspace example with STM32WB55 diffhist +6,692 Registered User (Creation of step by step example with qualification process and STM32WB55) | ||||
| N 10:17 | ISP:ISP introduction diffhist +2,037 Registered User (Created page with "<div class="res-img"> center| 250px |link= </div> An image signal processor ('''ISP''') converts RAW image captured by a RAW sensor into a digital image. It is done by adjusting the ISP image quality parameters such as brightness, contrast, and color balance.<br>The STM32 '''DCMIPP''' (Digital Camera Interface Pixel Pipeline), an internal peripheral which is the pixel pipeline section of a camera subsystem, embeds an ISP developped by STMicroelect...") | ||||
20 November 2024
| 11:00 | STM32 KeygenTool diffhist −24 Registered User (Changed categories.) | ||||
| N 10:51 | Security:STM32N6 ROM trace analyzer diffhist +749 Registered User (Created page with "== ROM trace analysis procedure == ROM code traces cannot be downloaded directly. The process to get traces consists to use a special FSBL that will print the traces on UART. Here is a link where to download the FSBL sources : Load_a_signed_FSBL_and_get_the_BootRom_traces By default this FSBL permits to display bootrom traces on UART @115200 bauds, 8bits, 1 stop bit,...") | ||||
| 00:51 | Category:Getting Started wtih STM32 Command Line tools diffhist +26 Registered User (→test: new section) | ||||
18 November 2024
| N 05:29 | Category:Getting Started wtih STM32 Command Line tools diffhist +1 Registered User (saving page) | ||||