STM32 Sniffer for BLE Setup guide

Revision as of 14:09, 15 June 2023 by Registered User (→‎Introduction)
This message will disappear after all relevant tasks have been resolved.
Semantic MediaWiki
There are 1 incomplete or pending task to finish installation of Semantic MediaWiki. An administrator or user with sufficient rights can complete it. This should be done before adding new data to avoid inconsistencies.

1. Introduction

The STM32 Sniffer for Bluetooth® Low Energy is composed of two main parts.

  • The software part running on the computer : analyzes and displays packets
  • The firmware part running on the STM32WB MCU : intercepts over the air packets
System Architecture
System Architecture

2. Minimum requirements

2.1. Hardware

2.2. Software

3. Programming the board

4. Installing Wireshark plugins

4.1. Installing the external capture plugin

4.2. Installing the dissector plugin

4.3. Installing the profile

5. Configuring Wireshark

5.1. Enabling the interface toolbar

5.2. Testing

Retrieved from "https://wiki.st.com/stm32mcu/index.php?title=Connectivity:STM32_Sniffer_for_BLE_Setup_guide&oldid=35257"
No categories assignedEdit